Renishaw MP11 Manuel D'installation Et D'utilisation page 29

OUTER DIAPHRAGM INSPECTION
1. Remove the stylus
2. Unscrew the front cover.
3. Inspect outer diaphragm for
damage.
4. To remove outer diaphragm, grip
near the middle and pull upwards.
INNER DIAPHRAGM INSPECTION
5. Inspect inner diaphragm for
damage.
If damaged return the probe to
your supplier for repair.
DO NOT REMOVE INNER DIAPHRAGM
OUTER DIAPHRAGM REPLACEMENT
6. Screw tool fully into stylus holder.
Oil surface lightly.
7. Fit new diaphragm.
8. The diaphragm must locate
centrally in the stylus holder
groove.
9. Press diaphragm to expel
trapped air.
10. Remove tool.
11. Lightly smear medium grease
on front cover lower surface.
Then refit cover and tighten.
12. Refit stylus
6
10
5
7
11
8
11
9
1-17
12