Iberspa Ready2Enjoy Guide D'utilisation page 19

Leaks
1. The two small connections between the power pack and the spa are
leaking: Ensure the garden hose style washer inside each of these fittings
is still in place and undamaged. If the washers are in place and the
connection is still leaking, there may be a small piece of plastic behind the
hose washer. Remove the small piece of plastic with a utility knife or
needle-nose pliers.
2. Blower connection is leaking: If the large connection between the spa and
the power pack is leaking, ensure the o-ring inside the fitting is in place
and undamaged.
3. Plumbing or pressure switch is leaking: Look under the power pack. If
water is coming from underneath the power pack, then the plumbing or
pressure switch inside the power pack is leaking. Contact the factory for
instructions.
No Heat
1. Dirty filter: Clean the filter per the instructions provided in the Maintenance
section of this manual. If the filter is more than two months old, replace it.
After cleaning or replacing the filter, cover the spa, turn the temperature
set point all the way up, and leave the spa for 24 hours. If the spa still will
not heat, contact the manufacturer for instructions.
2. No circulation, water pump air bound: Unplug the power pack from the
electrical outlet. Bleed air from the filter tank by turning the bleed fitting on
the top of the filter tank counter-clockwise. After one minute, or when
water drips from the fitting, close the bleed fitting and plug in. If the water
pump still does not pump water, contact the manufacturer for instructions.
If the water pump becomes air bound again, check the o-ring on the top of
the filter tank. Refer to the filter changing instructions in the Maintenance
section of this manual. Replace the o-ring if necessary.
3. Bad power pack: Ensure power is available to the spa. Check the circuit
breaker at the main electrical panel. Connect another electrical appliance to
the plug used for the spa. If power is available to the spa, test the GFCI
using the instructions supplied in the Maintenance section. If the GFCI is
working properly and the power pack does not function, then the power
pack is bad. If the GFCI is not working properly, do not use the spa.
Immediately contact the manufacturer for instructions.
ENGLISH