Iberspa Ready2Enjoy Guide D'utilisation page 10

6.When installing the caps on the inflation fittings, make sure the sealing flaps
on the fittings are not pulled out through the inflation fittings. This will prevent
the flaps from sealing properly, and may damage the inflation fittings.
7.Check the fit of the nylon outer cover on the spa. The openings in the side of
the nylon skin should be centered on the power pack connections. If not, let
some air out of the side tubes and adjust the nylon skin to center the power
pack fittings in the openings. Fill all side tubes until they are just firm.
8.Inflate the inflatable bladder cover. There are two inflation fittings on the
inflatable bladder cover. Pinch the transparent fill valves while filling the cover
to ensure good air flow through the valve.
NOTE: After inflating the spa and cover, unplug the power pack while
assembling and filling the spa with water.
9. Attach the three feet to the bottom of the power pack.
10. Line up the water connections on the back of the power pack with the
fittings on the side of the spa.
11. Remove the two labels from the bottom, large fitting of the spa. Make sure
the o-ring inside the fitting is in place.
12. Attach the bottom, large fitting on the back of the power pack to the
corresponding fitting on the spa, being careful not to cross-thread the
fitting. Make sure the o -ring inside the fitting is properly seated. Tighten
the nut hand-tight.
ENGLISH