Iberspa Ready2Enjoy Guide D'utilisation page 17

4. Unscrew the retainer ring from the filter
housing and remove the filter housing
cover.
5. Lift the filter out of the filter housing.
Clean the filter with the spray from a
high pressure garden hose.
6. Place the filter back in the filter housing.
Make sure the filter is properly seated in
the housing and that the o-ring is
properly seated in the o-ring groove.
7. Install the filter housing cover and
secure with the retaining ring. Tighten
the retaining ring hand-tight. Do not
over tighten the retaining ring.
8. Remove the caps from the spa suction
and discharge fittings inside the spa.
9. Open the air bleed fitting on the top of
the filter housing. Leave the bleed fitting
open for one minute, or until water drips
from the bleed fitting. Close the bleed
fitting.
10. Plug the power pack into the electrical outlet.
11. Reset the desired temperature set point
.
ENGLISH