Iberspa Ready2Enjoy Guide D'utilisation page 14

Turbo Operation
To turn the turbo wave pump on or off, push the on/off button. Look to see if
the spa blows bubbles uniformly all the way around the spa. If action seems to
fade as bubbles circle the spa and are weak on one side, then the lower air
chamber is over-inflated. Let some air out of the lower chamber to correct this.
The turbo wave pump will automatically shut off after 15 minutes of operation.
When the turbo wave blower system is activated, the blower pump is pumping
outside ambient air into the spa, creating much of the action in the spa. Some
cooling of the water will occur as the turbo wave blower operates. This is
normal and the heater will recover lost temperature after use. Remember, at
elevated temperatures, 15 minutes soaking time is considered safe.
The spa power pack contains a filter to help keep the water in the spa clean. If
the filter becomes dirty or clogged, water flow through the power pack will be
restricted. This may prevent the spa from heating up. Refer to the Maintenance
section of this manual for information on checking and cleaning the filter.
Cover
After use, place the cover on the spa. Lock the plastic clips in eight locations on
the outside of the spa.
Always leave the cover locked and in place when the spa is
not in use. The cover is not a replacement for adult
supervision. Always supervise young children in and around
water.
NOTE: The cover must be in place for the spa to heat up.
ENGLISH