Ariens ProZoom 2760S Manuel D'utilisation page 10

Tires
See Specifications on page 34.
CAUTION: Avoid injury! Explosive separation of
tire and rim parts is possible when they are
serviced incorrectly:
• Do not attempt to mount a tire without the
proper equipment and experience to perform
the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and tire
assembly. Heat can cause an increase in air
pressure resulting in an explosion. Welding
can structurally weaken or deform the wheel.
• Do not stand in front or over the tire
assembly when inflating. Use a clip-on chuck
and extension hose long enough to allow
you to stand to one side.
Hardware
Check for loose hardware.
Check Safety Interlock System
Check to see that the interlock system operates correctly.
(See Check Safety Interlock System on page 10.)
WARNING: FAILURE OF INTERLOCK together
with improper operation can result in severe
personal injury.
Lubrication
Lubricate all fittings per maintenance label under seat and
check hydraulic oil level. (See Lubrication and Maintenance
on page 19.)
Hydraulic Oil Service
The power unit is shipped with hydraulic oil in the system. If
the tracking is erratic, purge the system. (See Hydraulic
System Maintenance on page 20.) If the oil level is below the
edge of the baffle in the oil reservoir, fill with SAE 20W-50
motor oil.
Engine
Engine has been filled with a break in oil. Change oil and
filter after first 8 hours of use. (See Lubrication and
Maintenance on page 19.)
Check Function of All Controls
Ensure unit runs and performs properly.
WARNING: FAILURE OF CONTROLS could
result in death or serious injury.
GB - 10