Maintenance Instructions - Zivan MG 9 Manuel D'utilisation

Table des Matières

Les langues disponibles

Fix the battery charger to a stable surface through the appropriate holes inserted on the fixing flanges. In case of installation on a

•

vehicle it is advisable to use anti-vibration supports.

Ensure that no flammable materials are stored in the area surrounding the charger.

•

Ensure all ventilation ports are not obstructed, to avoid the overheating. Do not put the battery charger near heat sources. Make

•

sure that free space around the battery charger is sufficient to provide adequate ventilation and an easy access to cables sockets.

To recharge Lead Acid batteries: WARNING: Explosive Gas – Avoid flames and sparks. The battery must be positioned in a

•

correctly cooled place.

Verify that the available supply voltage corresponds to the voltage that is stated on the battery charger name plate. In case of

•

doubt, consult a retailer or local Electric Supply Authority.

In order to protect against electric shock, please observe the in force local regulations. If an RCD is used, it is warmly

•

recommended the use of a class B switch. Warning: in case of damage, the charger may generate pulsating fault currents with DC

components.

For safety and electromagnetic compatibility, the battery charger has a 3-prong plug as a safety feature, and it will only fit into an

•

earthed outlet. If you can not plug it in, chances are you have an older, non-earthed outlet; contact an electrician to have the outlet

replaced. Do not use an adapter to defeat the grounding.

In order to avoid voltage drop, thereby assuring 100% charge at the battery, the output cables must be as short as possible, and

•

the diameter must be adequate for the output current.

After the installation make sure that all opening and doors of the charger are closed and secured

•