Niko 10-555 Mode D'emploi page 22

10-555 / 10-555-50 / 10-585 / 10-585-50
Setting times
By default, the following times are programmed:
Speech time after initiating a call
Time that the camera image remains active
Number of times the red LED blinks when someone tries to set up a call
while you are keeping the system busy (call or activated camera)
Number of times the red LED blinks when you pick up the receiver
or activate the camera while the system is busy.
Time of indication of a call
You can also set other times via
• the power supply (see manual of power supply 10-801, 10-802 or 10-806)
• the service unit (see manual of service unit 10-870)
• the relay (see manual of relay)
5. TROUBLESHOOTING
In case of problems, always first check with a multimeter whether the following voltages are present:
• between b and a: approx. +24VDC;
• between b and P: approx. +24 VDC;
• between M and P: approx. +24VDC;
• between M and V1 or V2: approx. +5VDC.
A list of possible problems with their causes and remedies is given below.
Problem
You hear a negative tone when
pressing .
The image on the video internal
unit is not clear.
No image on the video inter-
nal unit. The other functions
work OK.
No voice on the video internal
unit. Only the image is dis-
played.
22
Cause
Programming error.
System is still in programming mode.
Video internal unit is not connected
correctly.
Two functions assigned to the button.
Conductors V1 and V2 have been
reversed.
Cable is unsuitable:
• cable distance is too great;
• cable is eroded;
• cable cross-section too small;
• cable is not a twisted pair cable.
The gain on the splitters is not set cor-
rectly.
Wiring is not connected correctly:
• M or P missing;
• V1 or V2 not connected.
Jumpers not configured correctly.
Wiring is not connected correctly.
Max. 2'
80"
5 times within 10"
3 times within 6"
2'
Remedy
Erase the programming and programme again.
Exit programming mode.
Check the wiring.
If a call is in progress, the relay switches to open the door.
If no call is in progress, the light relay switches.
Reverse conductors V1 and V2.
Replace the current cable with a suitable cable.
Adjust the gain on the splitters with the potentiometers.
Check the wiring (see wiring diagram).
Set the jumpers correctly on the contacts (see chapter Installation)
Check the wiring (see wiring diagram).
EN