Getting Started - Napoleon BIPRO 500 Manuel D'instructions

Masquer les pouces Voir aussi pour BIPRO 500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16
CAUtION!
glasses for your protection. Although we make every effort to make the assembly process as problem
EN
free and safe as possible, it is characteristic of fabricated steel parts that the edges and corners might
be sharp and could cause cuts if handled incorrectly.
WARNING!
The best option is to install components after all construction has been completed and the jobsite has been
thoroughly cleaned. If the components must be installed prior to the construction being completed, then exposed
surfaces need to be covered to prevent corrosion. All surfaces must be cleaned when construction is completed.
Do not use muriatic acid to clean masonry materials from any surfaces. The lime contained in some construction
materials is extremely corrosive. During its curing period, (1 - 2 months) it is recommended that a stainless steel
polish or wax (car wax is acceptable) be applied to prevent direct contact of the lime materials.

Getting Started

1. Remove all cart panels, hardware, and grill head from the carton. Raise lid and remove any
components packed inside. Use the parts list to ensure all necessary parts are included.
2. Do not destroy packaging until the grill has been fully assembled and operates to your satisfaction.
3. Assemble the grill where it is to be used, lay down cardboard or a towel to protect parts from being
lost or damaged while assembling.
4. Most stainless steel parts are supplied with a protective plastic coating that must be removed
prior to using the grill. The protective coating has been removed from some of the parts during the
manufacturing process and may have left behind a residue that can be perceived as scratches or
blemishes. To remove the residue, vigorously wipe the stainless steel in the same direction as the
grain.
5. Follow all instructions in the order that they are laid out in this manual.
6. Two people are required to set the grill head into the enclosure.
If you have any questions about assembly or grill operation or if there are damaged or missing parts
please call our Customer Solutions Department at 1-866-820-8686 between 9 AM and 5 PM (Eastern
Standard time).
TOOLS REQUIRED FOR ASSEMBLY (tools not included)
www.napoleongrills.com
During unpacking and assembly we recommended you wear work gloves and safety
Construction materials and masonry dust may cause surface damage to units and accessories.
3/8" (10 mm)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Built in bipro 500

Table des Matières