Connecting The Speakers - Pioneer VSX-519V-S Mode D'emploi

03 Connecting up

Connecting the speakers

A complete setup of six speakers (including the
subwoofer) is shown below, but everyone's
home setup will vary. Simply connect the
speakers you have in the manner shown below.
The receiver will work with just two stereo
speakers (the front speakers in the diagram)
but using at least three speakers is
recommended, and a complete setup is best for
surround sound. If you're not using a
subwoofer, change the front speaker setting
(see Speaker setting on page 33) to LARGE.
Make sure you connect the speaker on the
right to the right terminal and the speaker on
the left to the left terminal. Also make sure the
positive and negative (+/–) terminals on the
receiver match those on the speakers.
Be sure to complete all connections before
connecting this unit to the AC power source.
IN
L
R
T IN
L
ANTENNA
R
FM
16
En
AUDIO
FRONT FRONT
R R
ZONE2 OUT
SUBWOOFER SUBWOOFER
PRE OUT PRE OUT
R L
OUT DVR/VCR IN VIDEO
MONITOR OUT BD/DVD IN TV/SAT IN
P P Y
R B
OUT
Bare wire connections
Front speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
1
10 mm
Center and surround speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
1
10 mm
SPEAKERS SPEAKERS A A
L L
SURROUND SURROUND CENTER CENTER
R R L L
2 3
2 3
AC IN