Assembly - Baja motorsports DR150C Guide D'assemblage

WARNING:
Strictly adhere to all torque wrench tightening specifica-
tions. Failure to do so could cause serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
WARNING:
If any of the assembly steps have already been com-
pleted, verify the assembly was completed correctly, the
piece is securely tightened, and torque specifications are
correct, then proceed to the next step in the assembly
process. Use of a product that may have been improperly
assembled could result in serious personal injury.
INSTALLING REAR SHOCK
 Remove the nut and bolt from the frame as shown.
 Lift up the rear of the dirt bike and align the rear shock
with the holes in the frame.
 Reinstall the bolt and nut. Torque to 11.1-14.8 ft.lbs. (15-
20 Nm).
© 2010 Baja, Inc. All Rights Reserved.

ASSEMBLY

BOLT
INSTALLING FRONT FENDER
 Align the holes in the front fender with the holes in the dirt
bike frame as shown.
 Insert bolts through washers, then through fender and
frame. Tighten securely.
WASHER
BOLT
NUT
6 — English
FRONT
FENDER