Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Note. All-purpose programming can only refer to one day of the week; any pre-existing all-purpose
programming is cancelled.
①
①
If no button is pressed for 10 seconds, the arrows disappear and the countdown begins D.
When the set period is over, the device will go back to operating in automatic mode. To stop timed
manual mode, change mode by pressing the
Manual mode
To activate this mode press button
until the
A
Use the
zone temperature B; the value entered
remains valid until the operating mode or
set value is changed.
Note. If no button is pressed for 5
seconds the device shows the detected
temperature again.
B
Timed manual mode
If you want to keep the temperature
manual for a limited period, briefly press
on area ① in figure B.
The
manual mode has been activated; use
the
C
hours and minutes (in 15 minute blocks)
for which the mode will be active.
If you want to set an activation time for
the timed manual mode that is greater
than 24 hours, press area ① in figure
C and use the
days the mode will be active.
D
button.
icon B appears.
arrows to set the desired
icon C indicates that timed
arrows to set the number of
arrows to set the
A
Publicité
Table des Matières
