Assembly - Vacmaster VQ1220PFC Mode D'emploi

GB
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Attach the carry handle into the slots located on the top of the power head (Fig. 1).
3) Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 2).
4) Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed.
If the cartridge filter is not installed, refer to page 8.
5) Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub (Fig. 3).
6) For wet vacuuming, replace the cartridge filter with the foam filter supplied. Do not use a dust
bag when wet vacuuming. If the foam filter is not installed, refer to page 9.
7) Secure the power head back on the container, using the 2 side latches. Insert the locking end
of the hose into the suction port of the container (Fig. 4).
8) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.
Floor Nozzle Attachments
1) To remove the floor nozzle attachment, release the push clips on either side of the floor tool
holder. The attachment should drop out from underneath (Fig. 5).
2) To insert a new floor nozzle attachment, place one side of the attachment into the bottom of the
floor tool holder and secure one clip in place. Push the other side up into place and ensure it is
securely fitted into the holder (Fig. 6).
Hard Floor Nozzle
Attachment is suitable for wet or dry suction on hard floor surfaces. Ensure the squeegee is
located towards the back of the floor tool holder and brushes towards the front.
Carpet Floor Nozzle Attachment
Attachment is specifically designed for use on carpeted floor surfaces. Ensure the front lip is facing
away from the user and in the direction of vacuuming.

ASSEMBLY

8