Setup - Laerdal CPRmeter Mode D'emploi

2 Setup

Check the contents of the CPRmeter box. It should contain:
– the CPRmeter
– Red sleeve
– set of 3 CPRmeter Patient Adhesives in a resealable pouch
– Directions for Use
– Laerdal Global Warranty and WEEE-statement leaflets
– microSD™ Memory Card with SD™ Card Adapter
– 3V Lithium 123 (Li/MnO
Remove the protective film from the CPRmeter display screen before first use.
Inserting a new Battery
1. Unscrew the Rear Cover using a flathead
screwdriver (not supplied) or a coin,
and lift out the cover.
2. Insert a new battery into the battery
well, in the orientation as directed by the
battery symbol inside the well.
3. Ensure that the Rear Cover's vent
membrane is not soiled or damaged.
Refer to Chapter 6, Replacing the Rear
Cover for instructions.
4. Position the Rear Cover on the CPRmeter.
Thread the screws through the washers
and into the cover, and tighten the screws.
The CPRmeter's status light will flash green
every 5 seconds to indicate that it has
passed its self-test and the battery is OK
for use.
If for any reason the CPRmeter's status indicator light is orange or does not
flash green, refer to Chapter 7, Troubleshooting Guide for instructions.
Inserting a microSD™ Memory Card
Use of a microSD™ Memory Card with the CPRmeter is optional. Refer to
Chapter 5, Q-CPR
®
1. Remove the Rear Cover and Battery.
2. Insert a microSD™ card into the card
slot inside the battery well, in the
orientation as directed by the card
symbol inside the well.
3. Re-insert the battery and attach the
Rear Cover as described in the previous
section.
) battery
2
Review for further details.
8