Bimar HC506 Notice D'instructions page 25

If possible, work with the appliance on a flat,
smooth, horizontal surface and proceed as
follows: fit the bases on the feet and fix them with
the four screws provided "1" (3x6mm).
Fit the set of feet on the bottom of the convection
heater, and fix them by screwing in four screws
"2" for each foot (total 8 screws: 4x12mm); take
care to ensure that the feet are perfectly
horizontal.
When done, check that the foot mounting bracket
and convector heater are securely fixed
together.
Make sure that the power cable is correctly positioned and not in contact with hot parts or
sharp edges, or wound around the appliance or twisted.
In case of a fault or malfunction, switch the appliance off and have it checked by qualified
staff; repairs by unqualified staff may be dangerous and lead to the loss of warranty cover.
DESCRIPTION
Wifi convection heater, usable via Smartphone using an app with Android or iOS operating
systems.

Electronics with integral wi-fi allowing Smartphone-convection heater communication
via an App.

All functions are adjustable via APP: mode (stand-by/Low/High); Temperature setting
15-35°C; Timer 0-24h and Weekly programming.

Check that the router is for domestic use, that there are no access restrictions except
the password, that the Wi-Fi network is 2.4 GHz, and that there is a strong, uniform Wi-
Fi signal in the room where the device is to be installed.

During initial installation and configuration, make sure that the smartphone is
connected to the wi-fi network to be used for the appliance.
First Installation/Setup
1.1 Install the "BIMAR life Smart" App via Google Play (Android) or AppStore (iOS), or
scan the QR code provided here.
For Android For iOS
25