Bimar HC506 Notice D'instructions page 22

 Do not use the appliance if it is not functioning correctly or
appears damaged: if in doubt, call in qualified staff.
 Do not allow the appliance to overheat: check that the air
inlets and outlets are unobstructed and do not hang
anything above or below the appliance. In case of
overheating, the integral safety device will cut out operation
of the convection heater. To restart the appliance, remove
the plug from the power socket and wait for it to cool (about
20/30 minutes) and reconnect the plug.
INSTALLATION
 After removing the packaging, check that the appliance is intact; if in doubt, do not
use it and call in qualified staff. Packaging components (plastic bags, expanded
polystyrene, nails, etc.) must not be left within reach of children since they are
potentially hazardous. Any stickers or advertising leaflets affixed to the appliance
must be removed prior to use.
 Before connecting the appliance, check that the voltage values marked on the
nameplate are the same as those of the electrical mains, and that the power socket is
properly earthed. If the appliance's plug is not compatible with the socket, have the
socket replaced with another of suitable type by qualified staff, who must ensure that
the socket's wire gauge is suitable for the appliance's power draw. In general, the use
of adapters and/or extension leads is not recommended; if their use is unavoidable,
they must comply with current safety regulations and their current rating (amps) must
be no lower than the maximum current draw of the appliance.
 Take care to ensure that the air inlet and outlet grilles cannot become obstructed, to
avoid the risk of fire or overheating of the appliance (inspect regularly); do not cover
the appliance, or use it for drying laundry.
 The appliance can be used on the floor by means of the feet provided, or wall-
mounted with the aid of the expansion plugs: the wall must have a flat, even surface
and must be solid and heat-resistant.
Wall-mounting (see relevant images)
For this type of installation, use the wall mounting bracket and expansion plugs
provided (not the feet) and proceed as follows:
 Place the convection heater well away from other heat sources, flammable materials
(curtains, upholstery, etc.), flammable gases or explosive materials (spray cans) and
materials which may warp in heat. Ensure that gaps of at least 100 cm in front of the
convection heater, 25 cm between the heater and the floor, 100 cm between the
heater and the ceiling, and 50 cm at the sides, are left.
 The power socket must be easily accessible so that the plug can be removed easily
in an emergency; the appliance must not be placed under or near windows.
22