MSI XPower Serie Mode D'emploi page 55

▶ CH1/ CH2/ CH3 or CH1-3 tWR
Minimum time interval between end of write data burst and the start of a precharge
command. Allows sense amplifiers to restore data to cells.
▶ CH1/ CH2/ CH3 or CH1-3 tWTR
Minimum time interval between the end of write data burst and the start of a col-
umn-read command. It allows I/O gating to overdrive sense amplifiers before read
command starts.
▶ CH1/ CH2/ CH3 or CH1-3 tRRD
Specifies the active-to-active delay of different banks.
▶ CH1/ CH2/ CH3 or CH1-3 tRTP
Time interval between a read and a precharge command.
▶ CH1/ CH2/ CH3 or CH1-3 tFAW
This item is used to set the tFAW timing.
▶ Current CH1/ CH2/ CH3 or CH1-3 tdrRdTRd/ tddRdTRd/ tsrRdTWr/ tdrRdTWr/
tddRdTWr/ tsrWrTRd/ tdrWrTRd/ tddWrTRd/ tdrWrTWr/ tddWrTWr/ tsrRdTRd/
tsrWrTWr
These item show the advanced DRAM timings.
▶ Channel 1/ Channel 2/ Channel 3 or Channel 1-3 Advance Timing
Setting to [Auto] enables the advance memory timing automatically to be determined
by BIOS. Setting to [Manual] allows you to set the following advanced memory tim-
ings.
▶ Extreme Memory Profile (X.M.P.)
This item is used to enable/ disable the Intel Extreme Memory Porfile (X.M.P.). For
further information please refer to Intel's official website.
▶ Memory Ratio
This item allows you to set the memory multiplier.
▶ Adjusted DRAM Frequency (MHz)
It shows the adjusted DRAM frequency. Read-only.
▶ Uncore Ratio
This item allows you to set the uncore multiplier.
▶ Adjusted Uncore Frequency (MHz)
It shows the adjusted uncore frequency. Read-only.
▶ QPI Links Speed
This item is used to select the QPI link speed mode.
▶ QPI Frequency
This item allows you to set the QPI frequency.
▶ Adjusted QPI Frequency (MHz)
It shows the adjusted QPI frequency. Read-only.
En-45