Switch - MSI XPower Serie Mode D'emploi

Switch

This mainboard provides the following switch for you to set the computer's function.
This section will explain how to change your mainboard's function through the use of
switch.
Over-Voltage Switch
The switch is used to upgrade the maximum adjustment value of CPU/ QPI/ DDR/ IOH
voltage in BIOS setup. And then you can over-voltage the CPU/ QPI/ DDR/ IOH voltage
in BIOS setup.
Follow the instructions below to to upgrade the maximum adjustment value of CPU/
QPI/ DDR/ IOH voltage.
Switch 1 : is used to upgrade the CPU voltage adjustment range,
switching it to "ON" will upgrade the CPU voltage adjustment
range in BIOS.
Switch 2 : is used to upgrade the QPI voltage adjustment range,
switching it to "ON" will upgrade the QPI voltage adjustment
range in BIOS.
Switch 3 : is used to upgrade the DDR voltage adjustment range,
switching it to "ON" will upgrade the DDR voltage adjustment
range in BIOS.
Switch 4 : is used to upgrade the IOH voltage adjustment range,
switching it to "ON" will upgrade the IOH voltage adjustment
range in BIOS.
Important
• While you enable OC Genie to detect your system configuration, please don't turn on
any parts of V-switch simultaneously. That behavior would offer too much voltage for
device and would be possible to cause some damage of device.
• After you set the CPU/ QPI/ DDR/ IOH voltage in BIOS, you can check the CPU/ QPI/
DDR/ IOH voltage by measuring the Voltage Check Point with multimeter. Please
refer the following instructions to measure these voltages.
En-23