Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Work as Wireless Siren
When it works as a wireless siren, it should be connected with
wireless control panel in advance. When the control panel is
alarming, it hoots and the strobe light flashes to deter illegal
intruders.
Connect to Control Panel
Press the learn button for
0.5 second, siren beeps once
and enter connection status.
Press
[SOS]
or
[Arm ]
on the
panel, the wireless siren and
control panel are connected
successfully after one beep is
heard from siren.
Note:
Once the siren is in connection status, please press learn button again
to exit. One beep will be heard from siren.
When connecting to control panel, please don't trigger any other sensors to
avoid interference.
Disconnection
Hold the learn button till 2 beeps are heard to disconnect the siren
and control panel.
Work as Standalone Alarm Panel
When it works as a standalone alarm panel, it should be connected
with wireless sensors or wired sensors in advance, when the
intrusion is detected, it hoots and the strobe light flashed to deter
illegal intruders.
Connect with accessory:
press the learn button on the siren and
trigger the accessory once, the connection is successful after one
beep is heard from siren.
Wired Terminals
The siren has terminals for power supply and wired sensors. Just
connect the power line or wired sensors to the hardwired terminals.
Please make sure the positive and negative are distinguished.
-DC12V+
24-ZONE
Power:
DC 12V Input
Zone (normal zone mode):
Once the sensor in normal zone mode
is triggered, the system will alarm immediately.
ZONE
EN
Publicité
Table des Matières
