GYS BTW 300 Mode D'emploi page 9

Translation of the original instructions
3. Login: Enter the email address provided during registration. Tick the box «Remember account». Select «connection».
1. Download
CONNECTING THE TESTER
1- Ensure that the area is well ventilated before performing a test.
2- Before carrying out a test on the battery, make sure that the ignition is switched off and that the consumers are not
running. Close all doors and the vehicle hood.
3- Make sure that the battery terminals are clean. If necessary, clean them using a wire brush.
Any rust between the tester terminals and the battery connectors or between the battery connectors and the battery
terminals reduces the accuracy of the tester.
4- Connect the negative (black) terminal to the negative terminal of the battery. Connect the positive plug (red) to the
positive terminal of the battery.
OPERATING INSTRUCTIONS
1. Open the application
on the mobile phone and
connect.
4. Press «START TEST» to start the analysis.
5. Click on the test to be performed in the menu at the top of the screen :
9
2. Set up
2. Select «Scan» at the top right of the home
screen. If the TEST icon is displayed in red, it means
that the tester is connected. In this case, it is not
necessary to select «Scan».
BTW 300
3. Registration and login
3. Once connected, select «conti-
nue connected». The user can
name the tester. Move your finger
over to the test area and select
«Edit».
EN
9