Miele SLQL0 Mode D'emploi page 48

en
of at least 1.5 m in front and 0.5 m to
the right and left of the base station
(Fig. 05).
 Insert the supplied power supply plug
into the socket at the back of the
base station. You can wind excess
cable around the cable rewind. Guide
the cable through one of the two
cable runs (Fig. 06).
 Insert the country-specific power ad-
apter into the power supply until it
audibly engages and then plug it into
the selected power socket (Fig. 07).
Charging the rechargeable
battery (Fig. 08)
The rechargeable battery is supplied
not fully charged. Before using for the
first time, it must be fully charged while
the robot vacuum cleaner is switched
on (switch I/0 to I).
The battery can also be charged when
the robot vacuum cleaner is switched
off (switch I/0 to 0). In this case, the
vacuum cleaner indicators will not re-
act.
 Connect the robot vacuum cleaner
correctly to the charging contacts on
the connected base station.
As the rechargeable battery charges,
the status indicator flashes in the dis-
play.
The charging process takes up to 150
minutes for the Scout RX2 and up to
180 minutes for the Scout RX2 Home
Vision. The process is finished when the
rechargeable battery status indicator
lights up green permanently in the dis-
play.
48
You can then vacuum for up to one
hour with the Scout RX2 and up to two
hours with the Scout RX2 Home Vision.
Rechargeable battery status indic-
ator in the display
Red charged capacity approx. 0%
- 20%
Or- charged capacity approx.
ange 20% - 50%
Green charged capacity approx.
50% - 100%
Setting the time of day (Fig. 09)
Use the remote control to set the time
of day.
The default factory setting for the robot
vacuum cleaner is the 24-hour time dis-
play.
 Press the Clock button for at least
three seconds.
The indicator field flashes in the display.
 Press the OK button.
The hour display flashes in the indicator
field.
 Press the + or - direction button to
set the current hour.
 Press the OK button to confirm your
selection.
The minute display flashes in the indic-
ator field.
 Press the + or - direction button to
set the current minutes.
 Press the OK button to confirm your
selection.