Manual Operation; Remote Operation - EQUATION EF431SLY-V Mentions Légales & Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Place the front surround over the front of the fire aligning the slots in the brackets
at each side of the front panel with the lugs on the sides of the fire.
Again two people will be required for this operation.
INSTRUCTIONS FOR USE
The appliance can be operated either by the switches located on the top right
hand side of the fire or by the supplied remote control.

MANUAL OPERATION

This is done by operating the switches located at the top right hand side of the
fire. The standby rocker switch must first be switched on, the fire will beep to
indicate that it is powered up.
Press the "F" button once to turn on the appliance and fire effect. A red indicator
light will show to indicate that the fire is ON. Press the "F" button for 3 seconds,
this will operate the dimmer mode, hold the button down until the desired
brightness is obtained.
Press the 1000W button once for the low heat setting; press twice to switch off
the heat setting.
Press the 2000W button once for the high heat setting; press twice to switch off
the heat setting.

REMOTE OPERATION

The standby rocker switch located at the top right hand side of the fire must first
be switched on; the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the
buttons more than once within two seconds for the fire to operate normally.
EN
63

Publicité

Table des Matières
loading

Table des Matières