INSTALLATION
The fire must not be used until it is securely fastened to the wall.
Do not connect the appliance to the mains until properly fixed to the wall and
the instructions are read fully.
The minimum distances must be observed in the diagrams above.
For installation of the appliance, care must be taken not to damage concealed
cables.
Please be careful whilst drilling holes.
This appliance is designed to be permanently fixed to a wall at a minimum
height of 300mm.The wall bracket must be fitted horizontally and the cable
routed to the bottom right of the heater.
A distance of 600mm from bottom of heater to floor is recommended for
optimum viewing of fuel bed; for recommend fixing dimensions.
For optimum viewing, mark the top four screws fixing positions on wall in
accordance with the recommend fixing dimensions.
NOTE: ensure that the bracket is level by using a Spirit level whilst marking out
the hole positions.
Drill holes with a No. six drill bit.
Fix the wall bracket using that the plug and screws provided.
Attach the lower fixing bracket the base of the fire using the two small black
screws supplied; ensure the bracket is fitted so that it is level with the back.
Carefully lift the heater up ensuring that the top rear ledge of heater engages
with the wall bracket and is sitting centrally. This process should be carried out
by two people to avoid injury or damage to property or the appliance.
Gently bring the heater down against the wall.
Mark the lower fixing bracket two fixing hole positions on the wall,
remove the heater.
Drill the wall and insert the wall plugs.
Refit the heater to the wall and fasten the bottom fixing bracket to the wall
using the screws provided to permanently fix the heater in place.
Unpack the pebbles from the bag and place them along the light unit in the
desired position.
EN
62