Assembly; Commissioning; Shutting Down; Emptying And Cleaning - Gloria Type 10 Mode D'emploi

RZ_Wasserzuführgerät_980044-00_Text_EN_Wasserzufuehgeraet 19.10.17 15:58 Seite 16
5 Assembly >> Figure
6

Commissioning

WARNING
CAUTION
device. Always comply with the following safety information/safety measures:
Prior to each use, check the device to ensure fault-free condition and leak-tightness.
To perform the leak test, fill the container with water!
Inspect all screw joints for tight fitting.
6.1 Inspecting the safety valve >>
ATTENTION
Activate the safety/vent valve until the device is depressurised.
Observe max. fill level (see technical data).
6.2 Commissioning >>
ATTENTION
device. Always comply with the following safety information/safety measures:
The device must only be operated when suspended in a vertical or steep upright position.
Connect unit and rig with supplied hose.
Perform re-pumping if the spray pressure falls.
NOTE!
working with the optimum spray pressure. The permissible operating pressure of max. 3 bar should
not be exceeded.
Yellow mark:
You work with optimal spraying pressure.
Red mark:
You exceed the permissible operating pressure of max. 3 bar, the pressure gauge with
integrated safety valve blows the overpressure.
7

Shutting down

7.1 Emptying and cleaning >>
7.2 Maintenance >>
1
–
Before putting into operation, observe Chapter 2 "For your safety".
You may be exposed to hazards that could injure you when handling the
figures
10
You may be exposed to hazards that could injure you when handling the
>>
figure
11 The safety/vent valve A gives you information on whether you are
figures
16 –
4
5 9
–
figures
12
–
–
figures
13 15
17
16