Publicité
PowerXL FR7 and FR8 Series VFD
FR7 and FR8 mounting instructions
Lifting the FR7 or FR8 IP00 drive module without
the options module
Make sure that the support is attached to the bottom of
Step 1:
the drive. It gives the terminals protection when you lift
the drive or put it vertically on the floor.
A. Support/fixing bracket
Step 2:
Lift the drive with a lifting device. Put the lifting hooks in
the holes on the top of the cabinet. The maximum lifting
angle is 60 degrees.
After the lifting, you can remove the support if
Step 3:
necessary. You can also use it as a fixing bracket.
Lifting the FR7 or FR8 IP00 drive module with
the options module
Remove the drive from the package.
Step 1:
Use a lifting device that is sufficiently strong for the
Step 2:
weight of the drive.
Put the lifting hooks in the holes on the top of the
Step 3:
cabinet.
Lift the drive into a vertical position.
Step 4:
Step 5:
The maximum lifting angle is 60 degrees.
Install the AC drive in a vertical position at the rear plane of the
cabinet. We recommend that you attach rails on the sides inside the
cabinet. The rails make the drive more stable and the servicing easier.
Instruction Leaflet IL040047EN
Effective January 2022
EATON
www.eaton.com
7
Publicité
