Belt Adjustments - BH FITNESS S7TiB Guide D'utilisation

To adjust the running belt, stop the treadmill,
then use the Hex Wrench and adjust the Hex
Screw located in the Rear End Cap. If the
running belt is moving towards the left side,
tighten the left Hex Screw about 1/4 turn
(clockwise); if the running belt is moving
towards the right side, tighten the right Hex
Screw about 1/4 turn (clockwise); Turn the
treadmill on after it has been adjusted. If you
find that the belt has not moved to the proper
position, please repeat the steps above. Don't
use the treadmill until the running belt returns
to the center position.
The position of running belt might not stay
precisely in the center, it can and will shift
slightly towards the left and right sides,
however, you do not need to adjust the belt if it
is not rubbing against the side rails.
Depending on the usage of the product, please
apply silicon according to the chart to the
right. Use the Hex Wrench to unscrew the bolt
inside the Rear Roller. Then pull the belt up
and put some silicon to the center of the board.
After that, adjust the belt to the center of the
deck, followed by tightening the screw to the
original set.
When the belt is sliding, please follow the
above method to lubricate the running board.
20

BELT ADJUSTMENTS

Silicon Chart
Speed
KGS/LBS
6KM/hr Below
6~12KM/hr
KGS 12KM/hr Above
4mile/hr Below
4~8mile/hr
LBS 8mile/hr Above
Note: This maintenance is intended for household
use. If used for business, it is suggested to
examine the product every other month.
Interval
1 year
6 months
3 months
1 year
6 months
3 months