JB Systems Party Derby Mode D'emploi page 11

ENGLISH
Extra functions in the menu
 Press the [MENU] button until the display shows [SYS].
 Press the [ENTER] button if you want to enter this part of the menu with extra options.
 Use the [UP/DOWN] buttons to browse the extra functions in this System menu
o
[uErS] Shows the software version.
o
[LEdS] with this option you can decide if the display should be always on or if it can go out
after a while when no new information needs to be shown



o
[TEST] will start up an automatic test mode, so you can check if all the projectors and the
rotation motor are working.
o
[rESt] can be used to reset all the settings of the unit to the original factory settings

MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
This unit is radio-interference suppressed. This product meets the requirements of the current European and
national guidelines. Conformity has been established and the relevant statements and documents have been
deposited by the manufacturer.
Mains Input:
Fuse:
Total Power consumption:
Sound Control:
DMX connections:
DMX channels:
Derby LED power:
Flash LEDs:
Working temperature:
Size:
Weight:
You can download the latest version of this user manual on our website:
JB SYSTEMS
®
Press the [ENTER] button to enter the option settings
Use the [UP / DOWN] button to select the desired mode:

ON = function activated. When no new information needs to be shown on
the display, the display will turn off.

OFF = function deactivated. The LED display will be always lit.
Press the [ENTER] button to confirm your setting
Just press the [ENTER] button to reset the unit.
AC 100~240V, 50/60Hz
250V T1A slow blow (20mm glass)
28W
Internal microphone
3pin XLR male / female
1 or 5 channels
1x3W red + 1x3W green + 1x3W blue + 1x3W white LED
16x 0.5W white LED
10°C to 40°C
190 x 258 x 182mm
2kg
Every information is subject to change without prior notice
9/49
USER MANUAL
www.jb-systems.eu
PARTY DERBY