Lubrication - Silverline 817089 Mode D'emploi

817089
Cleaning
WARNING: ALWAYS wear protective equipment including eye
protection and gloves when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal
parts to wear quickly, and shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not
sufficient, a mild detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through
the ventilation holes (where applicable)

Lubrication

• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• Regularly check the condition of the brushes and replace if worn
• Always replace both brushes at the same time. A spare pair of brushes is supplied
• To replace the brushes, remove the Motor Cover (5) and carbon brush holders
• Insert new carbon brushes and refit the brush holders and Motor Cover
• After installing new carbon brushes run the machine at no load for 15 minutes
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools
that are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information
on the correct way to dispose of power tools
1600W Wall Chaser 150mm
silverlinetools.com
7