Revell Control Flyer 1903 Mode D'emploi page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1. GETTING STARTED:
Before switching on, ensure that the slide switch (the left stick on the remote control) is pointing
downwards. Now turn the control switch to "ON" (pic. 1). The Power LED lights up red and the
start/control LED fl ashes. First move the throttle stick upwards, then downwards again,
so that the control LED is constantly lit.
pic. 1
2. TRIMMING THE CONTROLLER:
The right trimming is the key to perfect fl ight of the aircraft. Adjustment is easy but requires some patience and feeling.
Please obey the following instructions exactly: Carefully move the thrust controller up and let the aircraft glide at low height above the ground.
3. FLIGHT CONTROL:
To take off or ascend, carefully move the thrust controller 3/4 of the way up.
To curve to the left, carefully move the steering controller to the left.
Attention: The pilot fi gure must be facing in the direction of fl ight.
Anleitung_Flyer1903_GESAMT03.indd 7
Anleitung_Flyer1903_GESAMT03.indd 7
Flying the Helicopter
Launching by hand
Hold the aircraft in one hand with the pilot fi gure facing in the direction of fl ight. After turning on the remote
control with the other hand, slowly move the thrust controller (slide switch) until full take-off speed is reached.
Carefully let the aircraft glide horizontally from your hand.
Attention: The propellers must rotate as evenly as possible. The steering controller must be positioned in the
middle to ensure this. Use the steering controller to maintain the fl ight path (see section 2 for help on trimming).
Now set the
ON/OFF switch
on the helicopter's
underside
to "ON".
If the aircraft fl ies
left or right unintentionally...
If the aircraft turns by itself either quickly or slowly to the left or right, press the left/right trim
control button until the aircraft stops turning by itself.
To land or descend, carefully move the thrust controller down. Only minimal adjustments to
the controller are needed for smooth fl ight.
To curve to the right, carefully move the steering controller to the right.
Attention: The pilot fi gure must be facing in the direction of fl ight.
7
12.06.2009 14:17:55 Uhr
12.06.2009 14:17:55 Uhr

Publicité

Table des Matières
loading

Table des Matières