Faber Stilo Isola Mode D'emploi page 8

DUE TO THE SIZE AND WEIGHT OF THIS RANGEHOOD, THREE PEOPLE ARE REQUIRED TO INSTALL THE CANOPY.
Two people must hold the canopy in place while the third person installs the screws that attach the canopy to the chimney.
The manufacturer assumes no responsibility for injury or damage caused by improper installations.
4. From below, attach the CANOPY SECTION (A in FIGURE
12) to the assembled chimney support using the four bolts
provided (E in FIGURE 12).
MAKE THE INTERNAL ELECTRICAL CONNECTIONS
5. Connect the CONTROL CABLES together as indicated in
A in FIGURE 13. Connect the LIGHT CABLES together as
indicated in B in FIGURE 13. Insert the connected CONTROL
CABLES (A in FIGURE 13) into the black plastic CONNECTOR
BOX (C in FIGURE 13) by connecting the two black plastic
pieces using the four screws provided. Using the two longer
screws provided, attach the assembled CONNECTOR BOX to
the METAL FLANGE (D in FIGURE 13).
A
B
A
D
FIGURE 13
WARNING
!
For ductless installations, install the CHARCOAL FILTER (F in
FIGURE 10) behind the center grease filter opening by inserting
and locking into place. See FIGURE 14
FIGURE 12
6. Install the grease filters using two hands by first pulling and
turning the knob to the left so that the locking lever does not
protrude from the filter (as in FIGURE 15). Insert the opposite
end of the filter into the retaining channel. Insert the knob end
next, then turn knob to the right to lock the filter into place.
C
7. Turn the power supply on. Turn on blower and lights. If the
B
rangehood does not operate, check that the circuit breaker is
not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
FIGURE 14
FIGURE 15
Version 07/11 - Page 8