VITO GARDEN VIRCR1000 Mode D'emploi page 44

indicator flashing does
not light
The robot lawn mower
runs outside the
boundary wire and
stops close to it;
Strange noise and
vibrations;
The working regular
time after each
charging has become
shorter;
The robot does not
start running after the
rain sensor has been
activated;
44
•
Wheels, specially the rear ones may
have a poor grip if covered with mud
or other debris;
•
In case of bad turning conditions,
slopes or wet grass near the boundary
wire, the robot may tend to slip across
the boundary wire while turning
direction;
•
The detection function of the
boundary wire does not work
properly;
•
The blades are blunt and the cutting
system is unbalanced;
•
The blade disc has been damaged
when it hit a hard object;
•
The nuts for fastening the blade disc
have loosened;
•
The robot and docking station
charging contacts are dirty;
•
Battery capacity is reduced after
repeatedly charging and discharging;
•
Rain sensor remains activated;
•
Clean the wheels of the robot
lawn mower and repair or
clean the lawn;
•
Your boundary wire is too
closed to the edge of the lawn.
It is advisable to move the
boundary wire inwards for
safety reasons;
•
Please refer to the "planning
instructions";
•
Reverse or replace the blade,
depending on the situation. It
is important to reverse or
replace all blades at the same
time;
•
Replace the blade disc;
•
Screw the nuts firmly;
•
Clean the charging contacts;
•
It is about time to buy a new
battery in order to achieve
high efficiency;
•
Clean the two metal contacts;