Operating Instructions; Charging The Robot Mower; Testing The Docking Station; Setting And Start-Up - VITO GARDEN VIRCR1000 Mode D'emploi

OPERATING INSTRUCTIONS

Charging the robot mower

Place the robot mower in the docking station for
charging, even if the robot has been pre-charged.

Testing the docking station

▪ Connect the wire to the adapter and afterwards to
the socket. Shortly after, the LED battery status
indicator is turned on. Turn on the mower power
button and the LED battery status indicator flashes
green every second. When the robot lawn mower is
installed in the docking station and it starts charging,
the LED indicator flashes green every 0.5 second;
▪ When the robot is fully charged, the LED battery
status indicator shows a constant green light;
If the LED light keeps flashing after a long-time
charging (more than 3 hours), generally there is a
poor charging contact. The robot and docking station
charging contacts must be clean. It is advisable to clean
these parts once a week with steel wool or thin
sandpaper.
▪ Disconnect the IN-wire to the red terminal. The LED
battery status indicator flashes green and the alarm
starts beeping. After 30 seconds, the buzzer stops
beeping, but the LED indicator still flashes green. This
a way of making sure that there is no breakage on the
boundary wire;
▪ Reconnect the IN-wire to the red terminal and the
LED indicator now shows a constant green light again;
▪ The docking station is now ready to be used.
The "IN" arrow on docking station points towards the
working area.

Setting and start-up

Remove any objects such as roots, stones, tree
branches, toys, etc.
After installing and charging, you are now ready to do
the setting.
Initial PIN: 0000
If you want to keep this PIN press "OK" 4 times (each
time you press "OK", you change the digit).
If you want to change the PIN:
Press "SET" until lights up. Place the new PIN using
the arrow buttons, confirming on "OK".

AUTOMATIC START

Charge the robot's battery completely before you
switch it on.
1. Press the "ON/OFF" switch.
2. Press "SET" once.
Enter the PIN code, using the buttons with the
arrows
Always remember your PIN code.
3. Press "SET" once.
Set the desired working time.
4. Press "SET" once.
Set the desired working area.
5. Press "SET" once.
Set the start time.
6. Press the "START" button.

MANUAL START

Charge the robot's battery completely before you
switch it on.
1. Press the "ON/OFF" switch.
2. Press "SET" once.
Enter the PIN code, using the buttons with the
arrows
and then .
and then .
39