Black & Decker SPACEMAKER CG800C Mode D'emploi page 7

Grind time and yield:
MOUNT GRIND
¼ cup (23 grams) Coarse
Medium
Fine
Extra Fine
1
/ cup (31 grams) Coarse
3
Medium
Fine
Extra Fine
½ cup (47 grams) Coarse
Medium
Fine
Extra Fine
¾ cup (70 grams) Coarse
Medium
Fine
Extra Fine
GROUND COFFEE TIPS
• For a cup of rich, full flavored coffee use 1½ rounded tablespoons of ground coffee
for each 5½ oz cup of coffee.
• For optimum flavor it is best to grind the amount of coffee needed immediately
before brewing.
• Do not use the coffee grinder to grind spices or nuts; the coffee will share those
flavors.
• Blending 2 or more types of beans will result in a richer, more complex brew.
• It is important to clean the ground coffee bowl after each use; the residual oils from
the coffee will give an off flavor to the next batch of coffee ground.
USING THE MINI FOOD PROCESSOR
The mini processor is used to chop, mince, mix and puree foods to a smooth
consistency. Use the workbowl to chop fresh and cooked fruits and vegetables, fresh
herbs, cooked meats, fish and poultry; to make sauces, dressings and salsas; bread,
cookie and cracker crumbs.
11
SUGGESTED TIME
8 seconds
9 seconds
10 seconds
11 seconds
10 seconds
12 seconds
14 seconds
16 seconds
10 seconds
11 seconds
15 seconds
20 seconds
12 seconds
17 seconds
30 seconds
37 seconds
1. Place the chopping blade on the spindle in the center of the workbowl. With your
fingers on the top of the stem of the chopping blade give it a twisting motion while
pushing down to make sure it is securely seated on the spindle (Q).
Q
Important: Handle grinding blade carefully. It is very sharp.
2. Place up to 1¼ cups (135 g) of food to be processed into the workbowl.
3. With your fingers on the top of the stem of the chopping blade give it a twisting
motion to make sure the food is evenly distributed in the workbowl.
4. Holding the workbowl from the bottom securely insert the bowl up into the center
of the bottom of the motor housing with the arrow on the bowl directly under the
UNLOCK signage on the bottom of the motor housing (R).
R
5. Turn the workbowl clockwise until it locks into position. The LOCK
the housing should be aligned with the arrow on the workbowl.
Note: There is a safety feature on this appliance that will not allow the grinder to
operate unless the workbowl is securely in place.
6. Plug in the appliance.
7. Press and hold the ON/OFF (I/O) control button. To stop the chopper at any time,
remove your finger from the ON/OFF (I/O) button.
signage on
12