Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product may vary slightly from what is illustrated.
1
1. Mounted unit
† 2. Grinding bowl (Part # CG800-01)
† 3. Stainless steel grinding blade
(Part # CG800-02)
† 4. ON/OFF (I/O) pulse control button
† 5. Processing workbowl
(Part # CG800-03)
2
† 1. Mounting Parts
(Part # SDC-MOUNTING KIT)
16 Spacers
4 ½"
4 ¼"
4
"
3
/
16
4
1
/
16"
12 Screws
4 1"
4 1½"
4 2¼"
4 Washers
2. Mounting Template (in box)
3
† 6. Stainless steel chopping blade
(Part # CG800-04)
† 7. Storage lid (Part # CG800-05)
8. Cord storage (behind unit)
9. Cord management hook (behind unit)
†Consumer replaceable/removable parts
GETTING ST RTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting washers, screws and spacers for mounting and set them
aside in a safe place where they will not roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE LOC TION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing
location.
• DO NOT mount over any heating or cooking appliance such as your range or
oven.
• DO NOT mount over or near a sink.
• DO NOT mount under, in front of or behind any under-cabinet light fixtures.
Note: If you are mounting multiple †SpaceMaker™ appliances, they should not
be mounted flush to one another. llow at least 4" of space between appliances
for adequate cooling.
Note: If you are connecting this appliance to the receptacle of another
†SpaceMaker appliance such as the toaster oven or coffeemaker, make sure you
can easily unplug the appliance following use.
DETERMINE C BINET TYPE
Prior to taping the mounting template and beginning to drill your holes, determine
if your cabinet has a flat bottom (B) or an overhanging lip (C). If your cabinet is
flat, follow ST ND RD INST LL TION; if the cabinet has a lip, refer to SP CER
MOUNTING INST LL TION.
B
ST ND RD INST LL TION (FL T C BINET)
Important: lways wear protective glasses or goggles to prevent injury when
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
C
4
Publicité
Table des Matières
