Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. With cabinet doors open, place line selected on mounting template even with
the bottom front edge of your cabinet, and tape in place against the lip (H).
H
5. With the paper securely taped in place against the lip, fold the rest of the
mounting template back against the underside of cabinet surface, bending
it to remain flush against both the back of the lip and the underside of the
cabinet (J).
J
Important: Do not align screw holes on template with the partition between
cabinets, as this will prevent you from installing the appliance properly. Pay close
attention to where the drill holes will be set so as not to damage your cabinets
during mounting. Drilling through your cabinet's partition may cause damage to
cabinets and prevent proper installation.
6. Drilling from under the cabinet up, drill holes through the 4 places marked on
the template using a ¼-inch drill bit (see illustration E).
Important: lways ensure you are drilling straight up through the marked
mounting hole on the template. Drilling at an angle may prevent proper
installation and may damage cabinets if the drill bit pierces the partition.
7. Once holes are drilled, remove tape and mounting template and save template
with your instructions in case you move or wish to remount at a later time.
8. Wipe dust and debris off inside cabinet surface. lso, make sure under side of
cabinet is clean.
9. Place a washer inside the cabinet over each of the 4 holes you drilled.
7
10.
Now, use your ruler or the paper ruler provided to measure the overhang
height, placing your ruler vertically against the underside of the cabinet
behind the overhang. This number determines the number of spacers you
need, using a number of spacers equal to the overhang height.
For example, a 1" overhang would use 2, ½" spacers on each of the
holes (K).
K
11.
Place a washer inside the cabinet over each of the 4 holes you drilled.
12.
Drop one of your screws through each of the washers covering the holes
in the cabinet, from inside the cabinet down.
13.
Place the appropriate number of spacers determined in step 9 on each
screw to ensure the appliance will be even (L).
Note: If not enough spacers are available, use spacers on rear two screws only.
The front edge of cabinet will provide support for the two front screws.
L
Note: For spacer installation, you may require assistance in mounting in order to
hold spacers in place while securing the appliance at the same time. If assistance
is not available, use a small clamp to hold the spacers in place while you position
the appliance.
14. Once spacers are set, hold appliance up and tighten screws to secure. Screw
from inside the cabinet down.
Note: lways tighten screws to ensure the appliance does not move or shake
during operation.
15. Pull out cord from cord storage behind appliance and plug into standard
electrical outlet. Extra cord can be fed back into storage or hung over cord
management hook behind unit (see illustration F).
Note: If you are connecting this appliance to the receptacle of another
†SpaceMaker appliance such as the toaster oven or coffeemaker, make sure you
can easily unplug the appliance following use.
8
Publicité
Table des Matières
