Optional Equipment; Disconnecting The Battery; Warning - Audiovox VME 9325 BTA Mode D'emploi

Optional Equipment

• NAV101/NAV102
The VME 9325 BTA is "navigation ready." Before accessing any navigation features, you must purchase and install the NAV module. All installation
and operating instructions will be included with the NAV navigation module. Once the NAV is connected and operating properly, the NAV source
mode will become active. While the NAV is not installed, the NAV option appears gray, indicating the function is not available.
• Rear Camera
The VME 9325 BTA is "camera ready." Before accessing any camera features, you must purchase and install a rear video camera. Once the rear
camera is connected and operating properly, the CAMERA source mode will become active. While the camera is not installed, the CAMERA opti-
on appears gray, indicating the function is not available.
• BTM10
Before you can connect to a Bluetooth enabled device, you must purchase and install the Audiovox BTM10.
• J-Link 4 cable
For iPod video or photo playback, you must purchase the Audiovox jLink 4 (USB and 3.5 mm jack to 30-pin iPod connector) cable.

Disconnecting the Battery

.
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation
NOTE:
If the VME 9325 BTA is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If
the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a
short circuit.
WARNING! Only connect the unit to a12-volt power supply with proper grounding.
WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions.
WARNING! To reduce the risk of a traffic accident (except when using for rear view video camera) never use the video display function while
driving the vehicle. This is a violation of federal law.
WARNING! Never disassemble or adjust the unit.
WARNING! To prevent injury from shock or fire, never expose this unit to moisture or water.
WARNING! Never use irregular discs.
WARNING! To prevent damage to the mechanism inside this unit, avoid impact to the TFT monitor.
WARNING! Using an improper fuse may cause damage to the unit and result in a fire.
WARNING! The monitor employs an automatic motorized mechanism. To prevent damage to the core mechanism, please do not push, pull or
swivel the monitor manually.
4