Optional Accessories - Makita DHW080 Manuel D'instructions

TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
The washer does not start.
No water jet / weak water jet
Unstable water jet
Abnormal sound
Water leakage
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
Probable cause (malfunction)
No electricity
The switch is not turned on.
Residual pressure in the pump
Damaged battery or electric circuit
The high pressure washer has been
left for long time while maintaining high
pressure.
No water supply
Poor water supply
Poor water hose connection
Clogged hose, filter, or nozzle
Air is blocking the flow of water.
Damaged or worn nozzle
Pump or valve malfunction
Clogged nozzle
Poor water suction
The water is too hot.
Valve malfunction
The water is too hot.
Air is stuck in the pump.
Poor connection
Worn out sealings
21 ENGLISH
Remedy
Install charged battery cartridges.
Turn on the switch.
Pull the trigger.
Contact an authorized service center for repairs.
Switch off the high pressure washer, supply water
from a faucet to the inlet and squeeze the trigger
with keeping the water supply for a while. And then,
switch on the high pressure washer.
Make sure that the faucet is open. If using the suc-
tion hose set, introduce water into the hose.
Turn on the faucet.
Check the connection between the high pressure
washer and the water faucet.
Unclog the hose, filter, or nozzle.
Turn off the switch and then turn it on again while
squeezing the trigger.
Replace the nozzle.
Contact an authorized service center for repairs.
Unclog on the ejection hole of the nozzle using the
cleaner pin.
Check the water hose starting from the faucet for
any leakage or clogs. Turn on the faucet.
Supply cooler water.
Contact an authorized service center for repairs.
Supply cooler water.
Contact an authorized service center for repairs.
Check the connection between the high pressure
washer and trigger gun and as well as the water
faucet.
Contact an authorized service center for repairs.
Vario-Power spray lance
► Fig.42
Jet pressure can be adjusted by rotating the nozzle.
CAUTION:
When adjusting the jet pressure,
do not rotate the nozzle while pulling it toward the
trigger gun. The nozzle may come off from the trig-
ger gun and cause a personal injury.
Foam nozzle
Country specific
► Fig.43
Detergent can be sprayed as foam.
Washing brush (long)
► Fig.44
A nozzle equipped with a brush. Useful for washing out
dirt while scrubbing with brush.