Makita DHW080 Manuel D'instructions page 22

Suction hose set
► Fig.45
Replace the water hose with this set to supply water
from a tank or reservoir.
Rotating wash brush
► Fig.46
Three brushes inside rotate slowly when ejecting the jet. Suitable
for cleaning light dirt on a exterior wall, car body, bath tub, etc.
Lance extension
► Fig.47
Pipes to extend the length of the trigger gun. Three
different lengths are available by changing the number
of the pipes to be used.
Under body spray lance
► Fig.48
An extra long spray lance with angled nozzle. Best for cleaning
hard-to-reach areas such as car under body and roof gutter.
CAUTION:
Do not use the under body spray
lance with the lance extension.
Splash guard
► Fig.49
Reduces splash back when cleaning corners with the
dirt blaster.
Swivel joint
► Fig.50
Prevents the high-pressure hose from being twisted.
Connecting joint
► Fig.51
A joint to connect with a nozzle from other model.
Some optional nozzles require the connecting joint (optional
accessory) to attach to the trigger gun. Attach the connecting
joint to the trigger gun in the same way as the nozzle.
► Fig.52: 1. Nozzle 2. Connecting joint 3. Trigger gun
NOTE: The connecting joint is needed when using
the nozzles included with another model, HW112 or
HW121.
Pipe cleaning hose (10 m/15 m)
► Fig.53
For cleaning and unclogging plumbing and downpipes.
CAUTION:
Pay particular attention to the
water jet when using the pipe cleaning hose.
Highly intense water jet is ejected backward. Only
trigger the water jet when the nozzle has been
inserted into the pipe to be cleaned at least up to
the red marking.
Extension high-pressure hose (5 m/8 m/10 m)
► Fig.54
Extension hose to connect the high pressure washer
body with the trigger gun.
22 ENGLISH