With horizontal louvers opened 30° from the vertical plane. HSB units have top and bottom piping connections, HC units have side connections. All have copper tubes.
➀
V and PT models have copper tubes, VN and PTN models have cupronickel tubes.
➁
Mounting heights are maximum for heaters operating at standard conditions (2 lbs. steam or 220°F water with 60°F entering air). Heights listed for Louver or Cone-Jet
are with deflectors in fully-opened position. Refer to Figure 4.2 for correction of mounting heights under other operating conditions. Maximum mounting height will be
reduced as entering air temperatures exceed 60°F.
Figure 4.2 - Maximum Mounting Heights Correction Factors
1.3
1.2
1.1
1.0
.9
.8
.7
.6
.5
150
160
170
180
These correction factors are to be used as multipliers to correct the maximum recommended mounting heights of unit heaters when operated with steam pressures other
than 2 pounds or with water at other than average temperature of 220°F.