Oransi Erik Guide De L'utilisateur page 8

6. Place the pre-filter on top of the HEPA filter bracket with the wire
frame side pointing down.
7. Re-install the cover and close the latches. The cover only fits one
way. There is a cut out on one side of the cover to make room for the
user interface (fan speed knob, power switch).
Cover Installation Steps
a. Place the cover on
b. Face the small side of the unit that has the fan speed control and
press your hands on each of the two large white sides and lift
about an inch.
c. Lower the cover while pressing the white cover in and away from
you so the white sides rest in the track along the bottom long
sides and the 2 latches properly seat together at the bottom of
the cover.
d. Latch the clamps on the user interface side first and then clamp
the 2 clamps on the other side.
8. Plug in the air purifier and press the power switch to "On" (Reset).
9. Adjust the fan speed knob to the desired speed. It may take a couple
seconds for the fan to begin spinning.
8