Oransi Erik Guide De L'utilisateur page 11

6. Place the large carbon filter into the bracket with the V-shaped side
pointed down.
7. Place the 4" deep pre-filter on top of the large carbon filter and center
it with the wire frame side of the filter pointing down.
8. Re-install the cover and close the 2 latches on either side of the cover.
The cover only fits one way. There is cut out on one side of the cover
to make room for the user interface (fan speed knob, filter
replacement indicator, etc). Note: the latch that is near the top of
the interior housing is not used with the carbon filter.
9. Plug in the air purifier and press the power switch to "On" (Reset).
10. Adjust the fan speed knob to the desired speed. It may take a couple
seconds for the fan to begin spinning. For best performance we
suggest running the fan on a lower speed setting to increase contact
time with the carbon filter.
Note: See the instructions on pages 8 and 9 for more details on installing
the cover.
11