Setting Up With A Hepa Filter - Oransi Erik Guide De L'utilisateur

2. Getting Started.
Setting up with a main HEPA Filter.
1. Unlatch 2 front and 2 rear latches of the cover.
2. Lift the cover straight up by the carrying handles and set to the
ground.
3. Remove the HEPA Filter bracket from inside the housing. If you do
not see the bracket it may have fallen to the bottom of the housing.
4. Place the main HEPA filter into the housing with the rubber seal facing
down. Be careful not to touch the white filter paper.
5. Reinstall the HEPA filter bracket and clasp in place (optional). Insert
the large slot of the HEPA filter bracket into the horizontal opening of
the housing first and lower the other end so that the small notch of
the HEPA filter bracket is pointed upward and just above the clasp as
shown below. The HEPA filter bracket serves as a frame for the pre-
filter so ensure that it is not installed upside down.
HEPA filter bracket (may be silver in color)
7