Step 6 - Install Reflector - Uberhaus 70005028 HSS-A-GH Guide De L'utilisateur

.
.
.
Load Head Assembly by inserting hose into post.
Insert Head Assembly into post.
Control knob should be above decal on post.
.
Attach Head Assembly to post, and loosely install four
small bolts.
.
Tighten bolts securely.
Step 6 – Install Reflector
WARNING
Remove protective cover before assembly.
Note: If necessary for proper alignment of reflector
.
sections, loose each screw prior to further assembly and
retighten after sections are aligned.
Slide two Reflector
Panels together.
6
.
Insert one Small
Screw.
9 Small Screws
9 Small Flat Washers
Slide one Small Flat Washer over threaded end of
screw and screw on Cap Nut loosely.
.
.
Slide Reflector Plate
onto Reflector Panels.
Insert one Small
Screw.
.
.
Repeat procedure to complete the assembly of all four
sections.
Fully tighten all of the screws in the rolled edge.
9 Cap Nuts
.
Slide one Small Flat
Washer over threaded
end of screw and
screw on Cap Nut
loosely.