Seagate Scorpion 240 DDS-4 Autoloader Manuel D'installation page 25

Scorpion 240 Autoloader Installation Manual
3. Insert the cartridge into the magazine with the door facing
Figure 9. Inserting a cartridge into the autoloader
magazine
Loading a magazine into the autoloader
Caution. Do not load a magazine if all the LEDs are flashing;
1. Make sure the drive is powered on and operating
2. Hold the magazine so that the slot numbers are right-
3. Write protect or write-enable the magazine as
4. Insert the magazine into the autoloader with the triangles
toward the magazine slot, as shown in Figure 9.
this indicates that the drive is performing a power-
on self test.
normally.
side-up.
appropriate. See page A-38 for details.
facing into the autoloader bay, as shown in Figure 10 on
the following page. Gently push the magazine into the
autoloader bay until the autoloader mechanism senses
the magazine and pulls it inside.
Cartridge door
A-23