Installing The Internal Autoloader A; Configuring The Internal Autoloader A - Seagate Scorpion 240 DDS-4 Autoloader Manuel D'installation

A-10
Installing the internal autoloader
This chapter describes how to configure, mount, and attach
cables to the internal Scorpion 240 autoloader.
Configuring the internal autoloader
Before you install the internal version of the Scorpion 240 in
your computer, you may need to configure the drive to work
with your system.
Default settings
The default settings for the internal drive are listed below:
•
•
•
•
•
•
If these default settings are appropriate for your computer
system, then continue to "Mounting the internal autoloader" on
page A-15.
Changing jumper settings
To change the SCSI ID, parity checking, or termination power,
use the jumpers on the back of the drive, as shown in Figure
1 on the following page.
Note. Power down the drive before changing jumpers or dip
Scorpion 240 Autoloader Installation Manual
The drive is set for SCSI ID 6.
Parity checking is enabled.
SCSI terminator power is disabled.
Data compression is enabled.
Power-on self-test diagnostics are enabled.
MRS checking is enabled
(the drive will not write to non-MRS tapes).
switches. Changes take effect when the drive restarts.