Using Cartridges And Magazines A - Seagate Scorpion 240 DDS-4 Autoloader Manuel D'installation

A-22
4. As each cartridge is identified by the drive, the cartridge's
5. When all tests are completed, the LCD display shows the
Note. If your computer does not recognize the autoloader,
Using cartridges and magazines
Applying labels
When applying labels to a cartridge, observe the following
precautions to prevent the cartridge from getting stuck in the
autoloader:
•
•
•
Caution Do not place any labels on the autoloader
Loading cartridges in a magazine
Use only approved DDS cartridges in the Scorpion 240.
Approved Seagate cartridges are listed on page A-37. To load
cartridges into the magazine, follow these steps:
1. Make sure that the cartridges are write protected or write
2. Hold the magazine so that the slot numbers on the side of
Scorpion 240 Autoloader Installation Manual
slot number is displayed on the LCD.
message "READY" if a magazine is loaded. If no
magazine is loaded, the message "NO MAGAZINE" is
shown.
you may need to load the appropriate autoloader
module for your backup software. See your backup
software installation manual for additional information.
Apply labels firmly, only in recessed label areas.
Do not let labels extend beyond label areas or fold over
the edge of a cartridge.
Do not apply labels over other labels.
magazine, since this may cause the tape
mechanism to jam.
enabled, as necessary. See page A-37 for details.
the magazine are right-side-up.