Albrecht Bambini Mode D'emploi page 25

The levels 1 to 4 correspond to the sensitivity like a baby monitor:
OF VOX off, normal control with PTT button (default)
1 low sensitivity
2 medium sensitivity
3 high sensitivity
4 highest sensitivity
Monitor Function
In order to check for very weak signals, the automatic squelch can be disabled. This is
helpful at the edge of the range and communication is interrupted or if you just want to
listen to what is happening on the channel.
To enable or disable the Monitor function long press the MON-Button (On the left side
of the device below the PTT)
The Monitor Function is only available in PMR446 operation.
Roger Beep
The radio can send a tone sequence after releasing the PTT button.

Press the M button five times until

Press ▲/▼ to select

Short press the PTT button or simply wait 5 seconds
If the Roger Beep is active, the icon
The Roger Beep is only available in PMR446 operation.
Key Tone
A short beep tone is audible when a button is pressed. To switch the key tone:

Press the M button six times until bP is shown on the display

Press ▲/▼ to select

Short press the PTT button or simply wait 5 seconds
If the Key Tone is active then the icon
The Key Tone is only available in PMR446 operation.
Out-Of-Range Control in PMR 446 Mode
The out-of-range control is also available in PMR 446 mode:
AU
Select between
out-of-range control.
Activation or deactivation of out-of-range control is set on the unit, which wants to check the
range. Even if the remote unit has no out-of-range control activated you can check the range
from your unit.
on oF
or
on oF
or
Pb
(automatic on),
English
rb
is shown on the display
is displayed.
is displayed.
(only manual out-of-range test) or
OF
for no
25