Albrecht Bambini Mode D'emploi page 18

Chapter 1: Baby Monitor Function
Insert Battery
Before the first usage please charge each unit.
Remove the belt clip (pull spring and remove
towards bottom)
compartment.
Carefully insert the connector of the Li-Ion battery
into the socket in the battery compartment (the
red wire has to be on the right side).
Put the battery pack into the device. The two
wires should lie between the battery and the
connector.
Close the lid
Please connect each charging cradle with one of the supplied AC adapters to a 230V
wall outlet.
Place the device in the charging cradle. During charging, the Battery level indicator is
shown animated.
Channel Number
The channel number must be the same for both units!
There are 18 possible settings, for the baby unit 01b to 18b and for the parent unit 01P to 18P.
1 to 18 stands for factory preset combinations of PMR446 radio channels and CTCSS tones.
The numbers are only valid for this type of transceiver and there is no communication with other
brand baby monitors.
Set Channel

If the key lock is active, disable this first

Press ▲/▼ to select a baby monitor channel.

Press the PTT button to confirm or simply wait a few seconds.
The babysitter setup is completed.
This setting already includes the highest sensitivity setting for the baby unit and automatic
out-of-range control between baby and parent unit.
18
and open the
English
battery
Black Red