Albrecht Bambini Mode D'emploi page 19

Volume

Turn the On/Off/Volume knob to set the volume.
The volume setting of the baby device is important in case you want to talk to the baby.
Otherwise it is recommended to set the volume of the baby unit to a minimum at all times.
Set the volume level of the parent unit to the desired level.
Turning the Volume knob fully counterclockwise will turn the device off.
Set Baby Monitor Sensitivity
The VOX sensitivity can be set in 4 levels.
With initial installation the unit is set to level 4 (highest sensitivity)

If the key lock is active, disable it first

Short press the M button to access the VOX menu.
The display shows Uo, the current sensitivity setting is flashing on the right (01 to 04 or oF).

Press ▲/▼ to select a level between 01 (low sensitivity) and 04 (high sensitivity) or
oF (off).

Short press the PTT button or simply wait 5 seconds to confirm the settings.
Talk Back Function
If your baby cries for a longer period without pause you may want to talk to your baby to
calm it down. For this enable the Talk Back Function of the baby unit. This enables a
time-out timer inside the baby unit. After 20 seconds of continuous transmission the
transmitter is disabled for 10 seconds and the baby device is able to receive from the
parent device.
To enable or disable the Talk Back Function:

Long press the MON-button. The display briefly shows tb followed by the new
state on or of
Be sure that the volume of the baby device is set to a reasonable level.
Usage of the Talk Back Function:

Wait until the 20 seconds timeout-timer expires and the baby device pauses
transmitting.

Use the following 10 seconds to talk to your baby and calm it down by simply
pressing the PTT button on the parent unit and talk to your baby.
As long as your baby is quiet, you can speak from the parent unit at any time.
English 19