Albrecht Bambini Mode D'emploi page 21

LED lights
The Bambini devices have three white LEDs above the display. These can be used as night
light. On the parent device they serve for the visual indication of noise from the baby.
Baby device

Press the M button three times until FL is displayed left on the display. The
current setting, OF or 01 to 03 is flashing on the right side of the display

By pressing ▲/▼ select 01 to 03 to switch on 1 to 3 LEDs (only available on
the baby unit)
Select OF to switch off all night light LEDs
Parent device

Press the M button three times until FL is displayed left on the display. The
current setting, AU or 01 to 03 is flashing on the right side of the display

By pressing ▲/▼ change the setting

Select AU to activate the automatic visual noise indication. If the baby cries a
little bit, only 1 LED will light up. If it cries at a medium volume, 2 LEDs will
light up. If the baby cries loudly, all 3 LEDs will be illuminated.

Select 01, 02 or 03 if the visual noise indication will always show the same
amount of LEDs. So if you select 01 and the baby cries loudly, the device will
still only illuminate 1 LED.
External Microphone
For the baby monitor function we supply an external
microphone (type BM 1). We recommend to use it always
in case of baby monitoring. This has the following
advantages:

It is more sensitive than the build-in microphone
and therefore responds to a greater distance.

It allows you to extend the distance between
transceiver and baby crib – HF radiation is greatly
reduced!

It allows you to position the radio in optimum
location to optimize the range, such as the
windowsill or high up on a wardrobe.
Please locate the BM1 microphone in a position where the
baby cannot reach it. Use the supplied sticky pad to safely attach the microphone.
Flap the rubber cap of the EAR/MIC jack open and connect the microphone on the upper jack.
Note: If the external microphone is connected no settings can be made on the radio!
English 21